CeramicSpeed Ceramic Race Bottom Bracket - PF30 to 25mm (Campy UltraTorque)

CeramicSpeed Ceramic Race Bottom Bracket - PF30 to 25mm (Campy UltraTorque) Info

This CeramicSpeed Coated Ceramic Race Bottom Bracket kit is designed to work with Campagnolo Ultra-Torque cranks on PF30 bottom brackets. The Ultra-Torque spindle, a two-piece 25mm diameter pipe is a classic design. With CeramicSpeed’s help, you can make it much faster.

The PF30, Press Fit 30, standard is based on the BB30 standard, and many see it as an improvement. The shell here is 46mm in diameter rather than 42mm of the BB30, and it still uses the 68mm shell width of the BB30. The extra diameter allows BB30 bearings to fit inside cups that are pressed in to the shell, rather than pressing the bearings into the shell and against a clip that sits in a machined groove. The result is a lighter setup that is simpler to manufacture.

The aluminum cups themselves are on the inside of aluminum sleeves. The pieces are machined by Rotor in Spain. On Ultra-Torque cranks, the bearings are pressed onto the spindles, so you’ll need a puller to remove the bearings that you are replacing.

CeramicSpeed is an innovator in bearing technology. They mastered the use of ceramic ball bearings pressed into hardened steel races for both reduced friction and improved durability. You can go faster with less maintenance. Great things both. These are the reasons why pro teams seek out ceramic bearings. CeramicSpeed has the pro teams coming to them, begging for bearings. Even the ones they don’t sponsor might well be using them in order not to be left behind.

If you replace all your bike’s bearings with CeramicSpeed, you could be looking at a savings of 25 seconds in 40km if you’re riding at 48kph. The savings goes up to two minutes if you’re riding at 32kph. Extend that to an Ironman-length ride, and the savings could vary from 1:50, if you’re going 48kph to nine minutes if you’re going 32kph.

CeramicSpeed utilizes Grade 3 Silicon Nitride balls that possess the best possible surface finish and roundness. In testing, the balls are 400% smoother, 128% harder, and 58% lighter than standard steel balls found in most bike components. They’re more than 100% smoother and 15% harder than standard ceramic balls. The balls are installed into hardened steel races in dust-free clean rooms and then checked again before assembly is complete. Not only is low friction the result, but so is increased bearing life. Like three to five times longer than standard bearings.

Another step they take in assuring the lowest-possible frictional drag is using grease they designed as lubricant. It comes in the bearings and a syringe comes with the bearings as well.

This kit comes with the bottom bracket assembly, wave washer, grease, and the requisite sticker sheet.

CeramicSpeed’s PF-30 Coated Campy Ultra-Torque bottom bracket helps you climb past your previous best.